Lets first take a look at how to make all the connections from the relay harness:

1) Now to the car, refer to the owners manual with the car to replace the stock halogen bulbs with the Prolumen HID bulbs, it was impossible to take pictures of this due to the angle of the headlights.

2) Now that the bulbs are in place we need to make the relay harness connections.

3) First remove the battery box cover and connect the red fused power wire from the relay harness to the nut on the positive battery terminal as shown below:

4) Then take the black ground wire from the relay harness and connect it to a grounding point, I like to use an existing screw in the car so ensure that the ground touches bare metal, I used a hood pop trigger you can use anything or install it using a metal tap screw.

5) Next mount the relay harness itself, I used a self tapping screw to mount it on the battery box itself, you can mount it anywhere.

6) Next we will use the white signal wire. (Signal wire it to tell the relay when it should turn on). You will need a tap-in for this part they can be found at your local hardware store to electronics store, they will look like this:

7) Remove your turn signal harness from the headlight itself its on the outside of the headlight

8) You will need to use the tap-in to connect the signal wire to the white with orange stripe wire on the turn signal harness, it will look like this. Ensure you make a solid connection between the two wires. Note: you might need to remove some of the plastic covering to expose these wires.

9) Those are all the basic connections for the relay harness next we will start to connect the ballasts to the harness. Mount both ballasts and igniters somewhere secure using provided brackets or double sided tape/zip ties.

10) Time to make the ballast connections

11) Plug in both connections from the HID light bulbs

12) connect the black wire from the HID Wire Harness (Different then the HID Relay Harness) to a ground source, there are two ways to do this

 - connect it to the ground on the stock headlight harness

- or cut off the spade connector at the end and connect a ring terminal and ground it off to the chassis like the relay harness

13) Next you will need to connect the male spade connector from the ballast harness to the female connector on the relay harness:

14) And you are done turn on your HID's and Enjoy, this method will still keep your auto light feature working.